How do I connect hive hub to New WIFI?

How do I change the Wi-Fi on my Hive hub?

How do I change the Wi-Fi router or network that my Hive View or Hive View Outdoor is connected to?

  1. Head to your Hive mobile app and log in if required using your Hive username and password.
  2. Select the camera you wish to view from the dashboard.
  3. Select the “Settings” icon, and then “Change Wi-Fi”

How do I reset my Hive hub?

The Hive Hub can be reset by pulling the power cable out and putting it back in again. It will take about 5 minutes to fully reboot and pair to your devices. After the 5 minutes, refresh the app or website.

Can you connect a Hive hub via Wi-Fi?

Our newest hub, Hive Hub 360 connects via Wi-Fi, our other hubs need to be physically connected to your broadband router using a network cable (provided with the hub) to allow you to control your Hive products remotely.

How do I transfer hive hub?

Moving home with Hive – where to put your Hub If you're using Hive Hub 360, then place it somewhere centrally in your home to enable the best connection to your other Hive products. As it's WiFi based, you'll need to go through the 'change WiFi' process in the app to set it up for your new home.

How do I activate hive hub?

Log in to the app or website and enter the Hub ID (this is found on the underside of the hub). Click “Go” and your hub will begin to search for devices. Follow the on-screen instructions to add your devices. If you have a Hive Hub 360 as shown below, follow our guide here.

Are Hive hubs transferable?

Your Hive Hub can't be used by the new occupier of your home, so take that with you so you can install it in your new premises. If you'd like to continue using Hive Active Heating, you'll need to buy it for your new home if it's not already installed there.

How do I sync my hive hub?

If you already have a Hive Hub just put it into pairing mode. To do this press the button at the rear of the hub for 1 second and release it. The middle light should now flash AMBER showing it is in pairing mode.

Can hive Hub be transferred?

Your Hive Hub can't be used by the new occupier of your home, so take that with you so you can install it in your new premises. If you'd like to continue using Hive Active Heating, you'll need to buy it for your new home if it's not already installed there.

How do I reset my Hive receiver?

To reset the Hive Hub do the following:

  1. Remove the batteries then turn off the boiler and receiver.
  2. Wait 10 seconds then turn on the boiler and receiver.
  3. Press and hold the heating button for 15 seconds or so until the status light flashes white.

How do I change the wifi on my Hive hub 360?

How do I change the Wi-Fi router or network that my Hive View or Hive View Outdoor is connected to?

  1. Head to your Hive mobile app and log in if required using your Hive username and password.
  2. Select the camera you wish to view from the dashboard.
  3. Select the “Settings” icon, and then “Change Wi-Fi”

Does Hive thermostat use WIFI?

A smart thermostat connects your boiler to your smartphone via the internet. This means you can set, adjust and turn off the heating when you're at home and when you're not.

Are hive hubs transferable?

Your Hive Hub can't be used by the new occupier of your home, so take that with you so you can install it in your new premises. If you'd like to continue using Hive Active Heating, you'll need to buy it for your new home if it's not already installed there.

Published
Categorized as No category